New Ridges on Disc
The figure above shows the new 3D printed ridges that are officially going to be on the device
The figure above shows the team putting the new ridges on the 14 in diameter disc
The figure above shows the disc with all of the new ridges placed on the disc
Made the base support
The figure above shows the team cutting the wood to make the appropriate size of the base support
The figure above shows Carlos drilling the holes in each base support wood where the screws would be put to make the whole base support assembly
The assembled base support
The front view of the whole design with the new base support
The side view of the whole design with the new base support
No comments:
Post a Comment